JANYUN 3 Pieces Pen Shape Resin Mold Ballpoint Pen Silicone Molds Epoxy Resin Molds Resin Casting Molds with 75 Pieces Ballpoint Refill Pens for DIY Resin Crafts Making (Black)

Just what I ordered and fast

I absolutely love this kit. Super easy to use, makes beautiful pens, and the Ink/ballpoint write really well and beautifully. 10/10 all around. I take the ink cartridge and, leaving the red cover over the ballpoint, I put it in ballpoint first, then slip the other end into the mold but make sure the little nub goes inside the cartridge (this makes sure no resin gets inside and clogs it, causing ink to be unable to breathe) then I pour the epoxy slowly to avoid large and awkward air bubbles and once it’s been in for about 24 hours I slip it out of the mold, usually being able to bend the pen out so I don’t stress the mold, and I can either use pen right away while still a bit bendy or wait until it’s solid. Double check to make sure there’s a clear hole from exterior to inside of the ink cartridge otherwise the pen won’t work for long as the ink can’t breathe. If it got clogged don’t worry, just poke a tiny nail or a pin in the hole that’ll clear it up. There was a bit of a learning curve, first pen has lots of air bubbles, my newest is crystal clear. Highly recommend, I did rip a mold just a bit by being too rough with it (which is why I take the pen out earlier where I can bend it) But other than that it’s been amazing!

It is what I expected.

The media could not be loaded. So I read that many couldn't use the pen and make it work after I bought the molds and before I actually made one...... I know bad decision... But I still decided to try. How I made it was: I used UV resin to make the end of the ink that needs to breath be the first thing I made secure. I grabbed the molds put the pens making sure the end was exactly in the spot that it needs to sit in the mold. Then with the UV resin I added it to that end only to secure the end not the whole pen. I dried it and did the same to the other end where we write. Once the two were secure, I proceeded to make the design of the actual pen in the middle. I only had UV resin so I was able to dry the pen quickly, though I will say that as long as you secure both ends for the middle we can use regular resin and let it sit until thr middle is dry. Once they were dry I tested them all and they worked. The video is actually me writting with them the next day. I do agree a cap is needed, I'm trying to see if I can find a solution for it but overall I liked them a lot. If anything I can show a better video or just send a message for tips. I added a picture of how the whole for the ink stays open allowing the pen to breath and it let's it write. Hope that when you try it, it helps!

Makes pens no lid.

Works better than expected. I love them.

Great Product!!

I wouldn't even give this one star. The pens don't write and they don't seem to respond to me to help solve the problem. Very unhappy with this item. Don't purchase them!